Quick facts

Detailed TDS viscosity
450 cPs at 25 C
Catalogue viscosity
300 cPs
Detailed TDS gel time
15-20 minutes at 25 C
Catalogue gel time
15 minutes

Read the detailed Marble Resin TDS first

The detailed TDS is the product-specific source for water-white liquid form, typical 450 cPs viscosity at 25 C, 15-20 minute gel time at 25 C, 20-40 minute curing time at 25 C, 1.12 g/cm3 specific gravity, 35% styrene content, 32 C closed-cup flash point, three-month shelf life, 20-30 C storage.

These are supplied-resin and commercial references. They are not a formulation, a finished-component test certificate, a chemical-compatibility chart, a UV result, a filler-loading limit or a guarantee for a finished marble product.

Keep the catalogue differences visible

The catalogue identifies Marble Resin as a filled resin for cultured marble and onyx production and labels it Orthophthalic Unsaturated Polyester Resin. It lists 300 cPs viscosity and 15-minute gel time. The detailed TDS calls the product unsaturated polyester resin and lists 450 cPs and 15-20 minutes.

The repository does not provide a reason for the differences. A buyer should identify the exact document or product reference being evaluated and request confirmation, rather than combining the figures into a new claimed specification.

Use technical data for selection, not process instruction

Appearance, viscosity, gel-time and storage information help a buyer identify and compare a supplied grade. They do not establish the mineral system, filler level, pigment amount, resin-to-filler ratio, catalyst quantity, moulding method, cure schedule or polishing procedure for a finished marble composite.

Where the TDS uses high-level terms such as filler compatibility, smooth flow, high-gloss finish, low shrinkage and fully cured water or chemical resistance, it does not publish test methods, numerical limits or a finished-system approval. Keep those distinctions visible in internal requirements and procurement discussions.

Prepare a quote-ready Marble Resin brief

Start with the actual finished marble or stone component. State whether it is a cultured-marble, artificial-stone, quartz, engineered-stone, broad-FRP, PET sheet, putty or epoxy-system requirement. Then attach the current TDS, catalogue card, drawing or written specification if available.

Include required supplied appearance or finish, required published property or document, expected quantity, packaging requirement, delivery city or location and timing requirement. This supports an evidence-led grade discussion without asking for or publishing proprietary formulation details.

Frequently asked questions

Which Marble Resin values are published?

The detailed TDS lists water-white liquid form, 450 cPs viscosity at 25 C, 15-20 minute gel time at 25 C, 20-40 minute curing time at 25 C, 1.12 g/cm3 specific gravity, 35% styrene, a 32 C closed-cup flash point, storage, shelf life. Treat the values as typical TDS data.

Why do the TDS and catalogue differ?

The current Marble Resin catalogue card lists 300 cPs viscosity and 15-minute gel time, whereas the detailed TDS lists 450 cPs and 15-20 minutes. The repository does not explain the difference, so this guide does not average, replace or silently reconcile them.

What should I include in a Marble Resin RFQ?

Include the intended finished marble or stone product; exact TDS or catalogue reference; required supplied appearance or finish; required published technical data or documentation; quantity; packaging need; delivery location; and any drawing or written requirement. State quartz, engineered stone, putty, epoxy or another route explicitly where relevant.

Does this page guarantee availability or delivery timing?

No. Packaging and order quantity for Nepal are confirmed on enquiry. Stock, lead time, delivery and order-specific documents require confirmation for the actual enquiry.