Quick facts
- Published system context
- Gelcoat systems
- Gelcoat role
- Mould-side FRP surface finish
- MEKP role
- Separate catalyst / initiator component
- Buyer check
- Review actual gelcoat product data and component requirement
Two separate product roles in an FRP surface system
GP Gelcoat Resin is published as a mould-side polyester surface-coating product. MEKP Hardener is the separate catalyst / initiator component named in the current compatible-system context. They should not be compared as substitute products.
Begin with the required component and visible surface role, then review the specific gelcoat product data before including MEKP in a system enquiry.
Use application pages as component context
The existing site application guides cover FRP mould finishing, water-tank exteriors, boat and marine hull finishing, and bathware or sanitaryware. They provide component context but do not replace review of the current gelcoat and MEKP documentation.
A focused gelcoat-system enquiry
Share the moulded component, surface-finish requirement, relevant gelcoat product, expected quantity, application context if known and delivery location. This helps distinguish a gelcoat requirement from the separate structural resin, reinforcement and catalyst requirements.
Frequently asked questions
Is MEKP Hardener the gelcoat itself?
No. MEKP is the separately selected catalyst / initiator. GP Gelcoat Resin is the published mould-side surface-finish product.
Does this guide provide gelcoat application instructions?
No. It provides product-role and procurement guidance only. Review the current product data and discuss the actual system where needed.